Brother DCP375CW Service Manual page 233

Assembling Note:
• When mounting the upper cover:
- Make sure that the jam clear cover is not mounted.
- Make sure that the ink cartridge cover is open
- Make sure that the head/carriage unit is placed in the head capping position (home
position). This prevents the ink supply tubes from getting crushed between the upper
and lower covers.
- Take care not to deform the PF encoder disk
• After mounting the upper cover, check that the PF encoder disk is not bent or deformed
through the peep hole. (See the illustration on the previous page.)
(7) Place the upper cover upside down.
(8) Unhook the encoder guard spring from the spring guides provided on the upper cover.
(9) Release the other end (no spring) of the encoder guard film from the upper cover.
(10) Remove the encoder guard spring from the film, slide the film inwards, and take it out of
the upper cover.
Encoder guard spring
Encoder guard
film
Upper cover
Encoder guard film
6-40
Boss
Upper cover
placed upside down
(6_43)
(Front)
Confidential