Brother DCP375CW Service Manual page 235

Assembling Note: When mounting the ink cartridge cover, lightly lift up the frond end of
the lower cover, fit the two sockets over the bosses on the lower cover at the angle shown
below and rotate the ink cartridge cover. Then, set the cover arm on the rib on the right side
of the lower cover (see the illustration above).
Lower cover
For wireless LAN-enabled models, remove the front cover and WLAN PCB using the
following steps.
(4) Release the grounding wire* by removing the screw and disconnect the WLAN PCB
harness from the main PCB. (See the illustration on the previous page.) Then release the
grounding wire and WLAN PCB harness from the cable guides provided on the lower cover.
(5) Lightly lift up the front end of the lower cover and remove the front cover together with the
WLAN PCB.
(6) Release the two latches on the front cover and take out the WLAN PCB.
DCP375CW/395CN
MFC255CW/295CN
MFC495CW/795CW
WLAN PCB
Cutout
Linear boss
PCB support
section
Latch
Assembling Notes:
• For wireless LAN-enabled models
- When mounting the front cover and WLAN PCB onto the lower cover, route the
WLAN PCB harness and grounding wire* as shown on the previous page.
- When securing the grounding wire to the main PCB shield frame with a screw, set the
crimped section of the grounding terminal in the slit provided in the lower cover.
- When mounting the WLAN PCB on the front cover, fit the cutout of the WLAN PCB
to the PCB support section inside the cover.
• When mounting the front cover, lightly lift up the front end of the lower cover and fit the
linear boss provided on the inside bottom of the front cover over the bottom of the lower
cover.
110
Fit the sockets provided on the ink
cartridge cover over the bosses on
the lower cover.
Grounding wire
WLAN PCB harness
Latch
Front cover
6-42
Cover arm
Ink cartridge cover
(Ink_cartridge_cover)
DCPJ125/J315W
DCPJ515W/J715W
MFCJ220/J265W/J270W
MFCJ410/J410W/J415W
MFCJ615W/J630W
DCPJ140W
WLAN PCB
Linear boss
PCB support
section
Latch
Grounding
wire*
WLAN PCB harness
Latch
Front cover
(6_45)
* Except for DCPJ140W
Confidential