Mj/Ps Shield Box And Power Supply Pcb - Brother DCP130C Service Manual

6.1.10 MJ/PS Shield Box and Power Supply PCB

(1) If the main PCB shield frame has not been removed, disconnect the power supply harness from
the main PCB and remove screw "d" (shown on
(2) Remove the two screws ("e" and "f").
(3) Remove the MJ/PS shield box from the underside of the lower cover.
"e"
"f"
Power supply harness
page 6-35) from the main PCB shield frame.
U-shaped cutout
"e": Screw, pan (s/p washer) M3x8
"f": Taptite, cup S M3x6
6-37
Lower cover
MJ/PS shield box
(6_38)
Confidential