Adf & Document Cover Assy*1; Document Cover*2 - Brother DCP375CW Service Manual

6.1.3 ADF & Document Cover ASSY
Document Cover
(1) Turn the ADF & document cover ASSY
up.
(2) Insert the tip of a flat screwdriver into the slit provided at the front of hinge R, push the
latch inside the scanner cover to the front, and release hinge R from the scanner cover.
(3) Just as in step (2), release hinge L and then pull the ADF & document cover ASSY
(document cover
(4) Slightly turn hinges R and L and remove them from the ADF & document cover ASSY
(document cover
ADF & document cover ASSY*
2
Document cover*
Document front
1
sensor harness*
Document rear
1
sensor harness*
1
ADF motor harness*
1
Grounding wire*
Hinge L
Assembling Note: When mounting the ADF & document cover ASSY
cover, put a magazine or a stack of paper about 2 to 3 cm (one inch) thick between them to
secure room for looseness of harnesses. Do not use the one that may scratch or contaminate
the scanner glass.
*1
*2
*2
) up and off the scanner cover.
*2
).
1
Hinge R
CIS motor harness
*1
(document cover
Scanner cover
(scanner unit)
6-13
*1 For models with ADF
*2 For models without ADF
*2
) upright and slightly lift it
Hinge R
Latch inside the
scanner cover
(6_16_ADF_mini9e)
*1
on the scanner
Confidential
*1
*1