Defaulting The Unit; Defaulting The Master Code; Defaulting The System Parameters - Centurion SMART GUARD air Operating Instructions Manual

Defaulting the unit

Both the Master Code and the system parameters (timers,
alarm functions, etc.) can be reset to Factory Defaults.
This is useful when the Master Code has been forgotten or
the system parameters are in an unknown state.

Defaulting the Master Code:

Remove power. Reapply power while holding the
down for two seconds. A beep will then follow, indicating
that the Master Code has been reset to
If the Anti-default feature has been enabled, the pairing
between the receiver will be broken during this process.
The pairing will have to be re-established before the
system becomes functional.

Defaulting the System Parameters:

Remove power. Reapply power while holding the
3
keys down together for two seconds. A beep will then
follow, indicating that the System Parameters have been
reset to the Factory Defaults shown on the following
page.
If the user identifies that the pairing has been
broken, it is the user's responsibility to ensure
that the keypad has not been tampered with, i.e.
that additional codes have not been learned into
the system. It is advisable, upon realising that
the pairing has been broken, to completely
default the keypad and erase the codes memory,
or to restore the memory using a Backup
Memory Module.
page 31
1
1 2 3 4
2
key
.
and