D-Link xStack DGS-3400 Series Cli Reference Manual page 197

xStack
To delete the static host name entry "www.example.com":
DGS-3450:admin# delete host_name www.example.com
Command: delete host_name www.example.com
Success.
DGS-3450:admin#
show host_name
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display the static and dynamic host name entries:
DGS-3450:admin# show host_name
Command: show host_name
Static Host Name Table
Host Name
----------------------------------
www.example.com
www.exampla.com
Total Static Entries: 2
Dynamic Host Name Table
Host Name
----------------------------------
www.examplc.com
www.exampld.com
Total Dynamic Entries: 2
DGS-3450:admin#
enable dns_resolver
Purpose
Syntax
Description
Parameters
Restrictions
®
DGS-3400 Series Layer 2 Gigabit Ethernet Managed Switch CLI Manual
Used to display the current host name.
show host_name {static | dynamic}
The show host_name command is used to display the current host name entries. If the
parameters for "static" and "dynamic" are not specified, both static and dynamic host name
entries will be displayed.
static - Display the static host name entries
dynamic - Display the dynamic host name entries
None.
IP Address
------------------
10.10.10.10
20.20.20.20
IP Address
---------------
30.30.30.30
40.40.40.40
Used to configure the DNS Resolver state of the switch to enabled.
enable dns_resolver
The enable dns_resolver command is used to configure the switch's DNS Resolver state.
None.
Only Administrator and Operator-level users can issue this command.
TTL
------------
60 minutes
10 minutes
193