D-Link xStack DGS-3400 Series Cli Reference Manual page 405

xStack
DGS-3450:admin# config poe ports 1-4 state enable priority critical power_limit class_1
Command: config poe ports 1-4 state enable priority critical power_limit class_1
Power limit has been set to 4000mW (Class 1 PD upper power limit 3.84W + power loss on
cable).
Success.
DGS-3450:admin# config poe ports 5 state enable priority critical power_limit user_define
1000
Command: config poe ports 5 state enable priority critical power_limit user_define 1000
Power limit has been set to 1000mW.
Success.
DGS-3450:admin#
show poe system
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display PoE system:
DGS-3450:admin# show poe system units 1
Command: show poe system units 1
Unit 1 PoE System Information
---------------------------------------------------
Power Limit
Power Consumption
Power Remained
Power Disconnection Method : Deny Low Priority Port
Detection Legacy PD
If Power Disconnection Method is set to deny next port, then the system cannot utilize
its maximum power capacity. The maximum unused watt is 19W.
DGS-3450:admin#
show poe ports
Purpose
Syntax
Description
Parameters
®
DGS-3400 Series Layer 2 Gigabit Ethernet Managed Switch CLI Manual
Used to display the setting and actual values of the whole PoE system.
show poe system {units <unitlist>}
Display the setting and actual values of the whole PoE system.
units - Specified units that will be displayed.
If no parameter specified, the system will display the status of all supported poe units in the
systems.
None.
: 250(watts)
: 0(watts)
: 250(watts)
: Disabled
Used to display the setting and actual values of PoE port.
show poe ports {<portlist>}
Display the setting and actual values of PoE port.
portlist - Specified a list of ports to be displayed.
If no parameter specified, the system will display the status for all ports.
401