D-Link xStack DGS-3400 Series Cli Reference Manual page 306

xStack
disable jwac quarantine_server_monitor
Syntax
Description
Parameters
Restrictions
Example usage:
To disable Quarantine Server monitor function:
DGS-3450:admin# disable jwac quarantine_server_monitor
Command: disable jwac quarantine_server_monitor
Success.
DGS-3450:admin#
config jwac quarantine_server_error_timeout
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To set Quarantine Server error timeout:
DGS-3450:admin# config jwac quarantine_server_error_timeout 60
Command: config jwac quarantine_server_error_timeout 60
Success.
DGS-3450:admin#
config jwac redirect
Purpose
Syntax
Description
Parameters
Restrictions
®
DGS-3400 Series Layer 2 Gigabit Ethernet Managed Switch CLI Manual
disable jwac quarantine_server_monitor
Disable JWAC Quarantine Server function enabled previously.
None.
Only Administrator and Operator-level users can issue this command.
Used to set Quarantine Server error timeout.
config jwac quarantine_server_error_timeout <sec 5-300>
When Quarantine Server monitor is enabled, the JWAC Switch will periodically check if the
Quarantine works OK. If the Switch does not receive any response from Quarantine Server
during the configured error timeout, the Switch then regards it as working improperly.
<sec 5-300> - To specify the error timeout interval.
Only Administrator and Operator-level users can issue this command.
Used to configure redirect destination and delay time before an unauthenticated host is
redirect to Quarantine Server or JWAC login web page.
config jwac redirect {destination [quarantine_server | jwac_login_page] | delay_time
<sec 0-10>} (1)
This command allows you to configure redirect destination and delay time before an
unauthenticated host is redirected to Quarantine Server or the JWAC login web page.
0 means no delaying the redirect.
destination - To specify the destination which the unauthenticated host will be redirected to.
delay_time - To specify the time period after which the unauthenticated host will be
redirected. Unit of this timer is second.
Only Administrator and Operator-level users can issue this command.
302