D-Link xStack DGS-3400 Series Cli Reference Manual page 471

xStack
show subnet_vlan
Restrictions
Example usage:
This example shows how to show a specified subnet VLAN entry:
DGS-3450:admin# show subnet_vlan network 172.168.1.1/24
Command:show subnet_vlan network 172.168.1.1/24
IP Address/Subnet Mask
--------------------------
172.168.1.1/24
DGS-3450:admin#
This example shows how to display a specified IPv6 subnet VLAN entry:
DGS-3450:admin# show subnet_vlan network fe80::250:baff::0/64
Command: show subnet_vlan network fe80::250:baff::0/64
IP Address/Subnet Mask
--------------------------
fe80::250:baff::0/64
DGS-3450:admin#
This example shows how to show all subnet VLAN entries:
DGS-3450:admin# show subnet_vlan
Command:show subnet_vlan
IP Address/Subnet Mask
---------------------------
172.168.1.1/24
172.18.211.1/255.255.255.0
172.18.211.6/24
fe80::250:baff::0/64
Total entry:4
DGS-3450:admin#
config vlan_precedence ports
Purpose
Syntax
Description
®
DGS-3400 Series Layer 2 Gigabit Ethernet Managed Switch CLI Manual
vlan - If specify the vlan, all subnet vlan entries that associated with this vlan will be
displayed. If no parameter is specified, all subnet vlan entries will be displayed.
vidlist - Specifies a list of VLANs by VLAN ID.
None.
VLAN
------
10
VLAN
------
10
VLAN
------
10
20
5
10
Use this command to configure the vlan classification precedence.
config vlan_precedence ports <portlist> [mac_based_vlan | subnet_vlan]
This command is used to configure vlan classification precedence on each port.
You can specify the order of MAC-based VLAN classification and subnet VLAN classification.
If a port's VLAN classification is MAC-based precedence, MAC-based VLAN classification
will process at first. If MAC-based VLAN classification fails, the subnet VLAN classification
will be executed.
Priority
---------
1
Priority
---------
1
Priority
-----------
2
3
1
2
467