D-Link xStack DGS-3400 Series Cli Reference Manual page 230

xStack
Example usage:
To enable the Double VLAN feature on the Switch, thus disabling normal VLANs and GVRP.
DGS-3450:admin# enable double_vlan
Command: enable double_vlan
Current Double VLAN mode : Disabled
Enable Double VLAN need to reset system config. Are you sure ?(y/n)y
Success.
DGS-3450:admin#
disable double_vlan
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To disable the Double VLAN feature on the Switch
DGS-3450:admin# disable double_vlan
Command: disable double_vlan
Current Double VLAN mode : Enabled
Disable Double VLAN need to reset system config. Are you sure?(y/n)y
Success.
DGS-3450:admin#
create double_vlan
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
®
DGS-3400 Series Layer 2 Gigabit Ethernet Managed Switch CLI Manual
Used to disable the Double VLAN feature on the Switch.
disable double_vlan
This command, along with the enable double_vlan command, enables and disables the
Double Tag VLAN. When Double VLANs are enabled, the system configurations for VLANs
will return to the default setting, except IP address, log, user accounts, and banner setting, in
order to enable the Double VLAN mode. In the Double VLAN mode, normal VLANs and
GVRP functions are disabled. The Double VLAN default setting is disabled.
None.
Only Administrator and Operator-level users can issue this command.
Used to create a Double VLAN on the Switch.
create double_vlan <vlan_name 32> spvid <vlanid 1-4094> {tpid <hex 0x0-0xffff>}
This command is used to create a Double VLAN (service provider VLAN) on the Switch.
vlan <vlan_name 32> − The name of the Double VLAN to be created. The user is to enter an
alphanumeric string of up to 32 characters to identify this VLAN.
spvid <vlanid 1-4094> − The VLAN ID of the service provider VLAN. The user is to identify
this VLAN with a number between 1 and 4094.
tpid <hex 0x0-0xffff> − The tag protocol ID. This ID, identified here in hex form, will help
identify packets to devices as Double VLAN tagged packets. The default setting is 0x8100.
Only Administrator and Operator-level users can issue this command. Users must have the
Switch enabled for Double VLANs.
226