D-Link xStack DGS-3400 Series Cli Reference Manual page 333

Xstack dgs-3400 series layer 2 managed gigabit ethernet switch
Hide thumbs Also See for xStack DGS-3400 Series:
Table of Contents

Advertisement

xStack
config lldp notification _interval
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To change the notification interval to 10 seconds:
DGS-3450:admin# config lldp notification_interval 10
Command: config lldp notification_interval 10
Success.
DGS-3450:admin#
config lldp ports notification
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To change the SNMP notification state of ports 1 to 5 to enable:
DGS-3450:admin# config lldp ports 1:1-1:5 notification enable
Command: config lldp ports 1:1-1:5 notification enable
Success.
DGS-3450:admin#
®
DGS-3400 Series Layer 2 Gigabit Ethernet Managed Switch CLI Manual
Used to configure the timer of the notification interval for sending notification to configured
SNMP trap receiver(s).
config lldp notification_interval <sec 5 – 3400 >
Globally change the interval between successive LLDP change notifications generated by
the switch.
notification_interval – The range is from 5 seconds to 3400 seconds. The default setting is 5
seconds.
Only Administrator and Operator-level users can issue this command.
Used to configure each port for sending notification to configured SNMP trap receiver(s).
config lldp ports [<portlist>|all] notification [enable | disable]
Enable or disable each port for sending changes notification to configured SNMP trap
receiver(s) if an LLDP data change is detected in an advertisement received on the port from
an LLDP neighbor. The definition of change includes new available information, information
timeout, information update. And the changed type includes any data update /insert/remove.
<portlist> – Use this parameter to define ports to be configured.
all – Use this parameter to set all ports in the system.
notification – Enables or disables the SNMP trap notification of LLDP data changes detected
on advertisements received from neighbor devices. The default notification state is disabled.
Only Administrator and Operator-level users can issue this command.
329

Advertisement

Table of Contents
loading

Table of Contents