Tftp Client Commands - D-Link xStack DGS-3400 Series Cli Reference Manual

xStack
The TFTP Client commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in
the following table.
Command
download firmware_fromTFTP
download cfg_fromTFTP
upload cfg_toTFTP
upload log_toTFTP
upload attack_log_toTFTP
Each command is listed, in detail, in the following sections.
download firmware_fromTFTP
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To download firmware from TFTP:
®
DGS-3400 Series Layer 2 Gigabit Ethernet Managed Switch CLI Manual
Parameters
[<ipaddr> | <ipv6addr> | <domain_name 255>] src_file <path_filename 64> {[unit
< unitid 1-12> | all]} {image_id <int 1-2>}
[<ipaddr> | <ipv6addr> | <domain_name 255>] src_file <path_filename 64>
{[<config_id 1-2> | increment]}
[<ipaddr> | <ipv6addr> | <domain_name 255>] dest_file <path_filename 64>
{config_id <int 1-2>} {[include | exclude | begin] <filter_string 80> {<filter_string
80> {<filter_string 80>}} {[include | exclude | begin ] <filter_string 80>
{<filter_string 80> {<filter_string 80>}} {[include | exclude | begin ] <filter_string
80> {<filter_string 80> {<filter_string 80>}}}}}
[<ipaddr> | <ipv6addr> | <domain_name 255>] dest_file <path_filename 64>
[<ipaddr> | <ipv6addr> | <domain_name 255>] dest_file <path_filename 64>
{unit <unit_id 1-12>}
Used to download the firmware image from TFTP server.
download firmware_fromTFTP [<ipaddr> | <ipv6addr> | <domain_name 255>] src_file
<path_filename 64> {[unit < unitid 1-12> | all]} {image_id <int 1-2>}
This command is used to download a firmware image file from the TFTP server.
ipaddr - The IP address of the TFTP server.
ipv6addr - The IPV6 address of the TFTP server.
domain_name - The domain name of the TFTP server.
src_file - Used to identify the parameter "path_filename".
unit - Specifies which unit on the stacking system. If it is not specified, it refers to the master
unit.
all - When all is specified, the firmware image on all units will be updated.
image_id - Specifies the firmware image ID. If image ID is not specified, it refers to the
boot_up image.
Only Administrator and Operator-level users can issue this command.
TFTP C
492
75
C
LIENT OMMANDS