D-Link xStack DGS-3400 Series Cli Reference Manual page 532

xStack
DGS-3450:admin# config wac virtual_ip 30::20
Command: config wac virtual_ip 30::20
Success.
DGS-3450:admin#
config wac switch_http_port
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To config HTTP(s) port of the switch used by WAC:
Used to config HTTP(s) port of the switch used by WAC.
DGS-3450:admin# config wac switch_http_port 8888 http
Command: config wac switch_http_port 8888 http
Success.
DGS-3450:admin#
create wac user
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To create a WAC local user:
®
DGS-3400 Series Layer 2 Gigabit Ethernet Managed Switch CLI Manual
Used to config HTTP(s) port of the switch used by WAC.
config wac switch_http_port < tcp_port_number 1-65535> { [ http | https ] }
The TCP port for HTTP or HTTPs is used to identify the HTTP or HTTPs packets
That will be trapped to CPU for authentication processing, or to access the login page.
If not specified, the default port number for HTTP is 80, and the default port number for
HTTPS is 443.
If no protocol specified, the protocol is HTTP.
The HTTP cannot run at TCP port 443, and the HTTPS cannot run at TCP port 80.
tcp_port_number - A TCP port which the WAC Switch listens to and uses to finish the
authenticating process. The range of port number is 1-65535.
http - To specify the WAC runs HTTP protocol on this TCP port
https - To specify the WAC runs HTTPS protocol on this TCP port
Only Administrator and Operator-level users can issue this command.
Used to create a WAC local user.
create wac user <username 15> {[vlan <vlan_name 32> | vlanid <vlanid 1-4094>]}
The create wac user command allows you to create account for web-base access control.
This user account is independent with login user account.
If VLAN is not specified, the user will not get a VLAN assigned after the authentication.
username - User account for web-base access control.
vlan - Authentication VLAN name.
Only Administrator and Operator-level users can issue this command.
528