D-Link xStack DGS-3400 Series Cli Reference Manual page 183

xStack
Command
enable sim
disable sim
show sim
reconfig
config sim_group
config sim
download sim_ms
upload sim_ms
Each command is listed, in detail, in the following sections.
enable sim
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable SIM on the Switch:
DGS-3450:admin# enable sim
Command: enable sim
Success.
DGS-3450:admin#
disable sim
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To disable SIM on the Switch:
®
DGS-3400 Series Layer 2 Gigabit Ethernet Managed Switch CLI Manual
Parameters
{[candidates {<candidate_id 1-100>} | members {<member_id 1-32>} | group
{commander_mac <macaddr>} | neighbor]}
{member_id <value 1-32> | exit}
[add <candidate_id 1-100> {<password>} | delete <member_id 1-32>]
[[commander {group_name <groupname 64>} | candidate] | dp_interval <sec 30-
90> | hold_time <sec 100-255>]
[firmware_from_tftp | configuration_from_tftp] <ipaddr> <path_filename>
{[members <mslist 1-32> | all]}
[configuration_to_tftp | log_to_tftp] <ipaddr> <path_filename> {[members <mslist>
| all]}
Used to enable Single IP Management (SIM) on the Switch
enable sim
This command will enable SIM globally on the Switch. SIM features and functions will not
function properly unless this function is enabled.
None.
Only Administrator-level users can issue this command.
Used to disable Single IP Management (SIM) on the Switch.
disable sim
This command will disable SIM globally on the Switch.
None.
Only Administrator-level users can issue this command.
179