D-Link xStack DGS-3400 Series Cli Reference Manual page 529

xStack
DGS-3450:admin# enable wac
Command: enable WAC
Success.
DGS-3450:admin#
disable wac
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To disable WAC:
DGS-3450:admin# disable wac
Command: disable wac
Success.
DGS-3450:admin#
config wac ports
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To config state and other parameters of the ports:
®
DGS-3400 Series Layer 2 Gigabit Ethernet Managed Switch CLI Manual
Used to disable WAC function.
disable wac
The disable wac command disables WAC function; all authentication entries related to WAC
will be deleted.
None.
Only Administrator and Operator-level users can issue this command.
Used to config state and other parameters of the ports.
config wac ports [<portlist> | all] {state [enable | disable] | aging_time [infinite | <min 1-
1440>] | idle_time [infinite | <min 1-1440>] | block_time [<sec 0-300>]}(1)
The config wac ports command allows you to configure port state of WAC.
The default value of aging time is 1440 minutes.
The default value of idle time is infinite.
The default value of block_time is 60 seconds.
portlist - A port range to set their WAC state.
all - All the Switch ports' WAC state is to be configured.
state - To specify the port state of WAC
aging_time - A time period during which an authenticated host will keep in authenticated
state. "infinite" indicates never to age out the authenticated host on the port
idle_time - If there is no traffic during idle time, the host will be moved back to
unauthenticated state. "infinite" indicates never to check the idle state of the authenticated
host on the port.
block_time - If a host fails to pass the authentication, it will be blocked for a period specified
by "block_time".
Only Administrator and Operator-level users can issue this command.
525