xStack
The Utilization commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command
show utilization
Each command is listed, in detail, in the following sections.
show utilization
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display the ports utilization:
®
DGS-3400 Series Layer 2 Gigabit Ethernet Managed Switch CLI Manual
Parameters
[cpu | ports | dram { unit <unit_id>} | flash {unit <unit_id>}
Used to display real-time port utilization statistics.
show utilization [cpu | ports | dram { unit <unitid>}| flash {unit <unitid>}]
The show utilization command displays real-time CPU ,ports,dram or flash utilization
statistics
ports - Specifies a range of ports to be displayed. (UnitID:port number).
dram - To show dram memory utilization.
flash - To show flash memory utilization.
unit - Specifys the unit to be displayed. If not specified, all units will not be displayed.
None.
U
TILIZATION
521
83
C
OMMANDS