Lvds Support; Lvds Panel Config Select; Non-Edid Support; Lvds Mode - Congatec conga-IGX User Manual

17.4.1

LVDS Support

Determines whether the LVDS interface is available.
Disabled The LVDS interface is not available.
Enabled
The LVDS interface is available.

LVDS Panel Config Select

17.4.2
Determines the resolution of the LVDS (Low Voltage Differential Signalling) interface. The selected resolution should be the same as that of
the connected LCD panel.
By using the "LVDS" OEM tool, an additional LVDS adjusted parameters entry can be created, which enables the use of freely configurable
LVDS parameters.
17.4.3

Non-EDID Support

For LCD panels that do not support a DDC (Display Data Channel), no EDID (Extended Display Identification Data) is available.
For LCD panels without EDID support, Enabled must be set. T o install a Linux operating system, it may be necessary to initially select "Non-
EDID Support = Disabled", despite having a connected LVDS panel without DDC support. After the Linux and driver installation is completed,
"Non-EDID Support = Enabled" can be set again.
Disabled The LCD provides EDID.
Enabled
The LCD does not provide EDID.
17.4.4

LVDS Mode

The selected mode of the LVDS interface must be supported by the LCD panel used.
Copyright © 2014 congatec AG IGX1m02 76/134