Tools Required For Installation And Service; Controlling Server Power; Powering On The System - Sun Microsystems Netra 440 Service Manual

Tools Required for Installation and
Service
The following tools are required to install and service the system:
Screwdriver, Phillips No. 1
■
Screwdriver, Phillips No. 2
■
Screwdriver, long Phillips No. 2 (shaft at least 8 inches/120.32 cm long)
■
Adjustable wrench
■
Electrostatic discharge (ESD) mat, Sun part number 250-1088, or equivalent
■
Grounding wrist or foot strap
■
The last two items help protect the system against damage due to electrostatic
discharge. For more information, see

Controlling Server Power

Refer to the following sections to power the server on and off:
"Powering On the System" on page 22
■
"Powering Off the System" on page 26
■

Powering On the System

Refer to the following sections to power on the system either locally or remotely:
"Powering On the System Locally" on page 22
■
"Powering On the System Remotely" on page 25
■
Powering On the System Locally
Do not use this power-on procedure if you have just added any new internal option
or external storage device, or if you have removed a storage device without
replacing it. To power on the system under those circumstances, you must initiate a
reconfiguration boot. For those instructions, see
on page
22 Netra 440 Server Service Manual • August 2004
28.
"Avoiding Electrostatic Discharge" on page
"Initiating a Reconfiguration Boot"
32.