Starting Setup Utility - NEC Express5800 User Manual

Starting SETUP Utility

When you turn on the server, the NEC logo appears first. (Or, the POST (Power On Self-Test)
screen appears.)
After a few seconds, the following message appears at bottom left on the screen.
Press <F2> to enter SETUP or Press <F12> to boot from Network
Press F2 to start the BIOS Setup utility and display its Main menu.
If you have previously set a password with the BIOS Setup utility, the password entry screen
appears. Enter the password.
Enter password:[
Up to three password entries will be accepted. If you fail to enter the password correctly for three
consecutive times, the server halts. (You can no longer proceed.) Power off the server.
NOTE:
Administrator and User. With the Administrator password, you can
view and change all system parameters. With the User password,
system parameters available for viewing and changing are limited.
The server is provided with two levels of password:
]
Configuring Your Server 4-3