NEC Express5800 User Manual page 216

7-8 Maintenance
6.
Select [Test and diagnostics].
Select [End-User Mode] and the system diagnostics starts. The diagnostics will be
completed in approximately three minutes. When the diagnostics is completed, the screen
of the display changes as shown below:
Diagnostics tool title
TeDoLi (TEst & Diagnosis On Linux) Ver001.00 (Build020901.1.1m)
Start 10:06:58 End 10:09:58 Pass 000:03:00 TestTime 000:03:00
Test End : NormalEnd 03 AbnormalEnd 00 ForceEnd 00
[Enter] Detail Information [ESC] Return to Enduser Menu
Guide line
– Diagnostics tool title
Shows the name and version of the diagnostic tool.
– Test window title
Shows the progress of the diagnostics. "Test End" is displayed when the diagnostics
completes.
– Test result
Shows the start, end, and elapsed time and completion status of the diagnostics.
– Guide line
Shows the details of the keys to operate window.
– Test summary window
Shows the results of each test that executed the diagnostics. Move the cursor and
press the Enter key on the cursor line to display the details of the test.
When an error is detected by the system diagnostics, the relevant test result in the Test
summary window is highlighted in red, and "Abnormal End" is displayed in the result on
the right side.
Move the cursor to the test that detected the error, and press the Enter key. Record the
error message that has been output to the Detail Information screen and contact your
service representative.
<System>
MEM Memory
CACHE Cache
<SCSI>
HDD_02:000 DK32DJ-36W
Test End
16 count NormalEnd
49 count NormalEnd
89 count NormalEnd
Test window title
Test result
Test summary window