External Devices - NEC Express5800 User Manual

Keyboard
To set Numlock
Select [Advanced] - [Numlock] – [On]/[Off].
To use Windows 2008
Select [Advanced] - [Advanced Chipset Control] - [Enable Multimedia Timer] - [Yes].
Security
To set passwords on the BIOS
Select [Security] - [Set Supervisor Password] and enter a password.
Select [Security] - [Set User Password] and enter a password.
Set Supervisor password first, then User password.

External Devices

To set up external devices
Select [Advanced] - [Peripheral Configuration] and set up each device.
Internal Devices
To install the RAID controller card or SCSI controller card
Select [Advanced] - [PCI Configuration] - [PCI Slot n Option ROM] - [Enabled].
n: slot number
To clear the hardware configuration data (after installing/removing internal devices)
Select [Advanced] - [Reset Configuration Data] - [Yes] and reboot.
To install the internal floppy disk drive
Select [Main] - [Legacy Diskette A:] and change parameter to [1.44/1.25MB 3 2/1"].
Save the setting and restart the server. Run BIOS SETUP again, and select [Boot] -
[Excluded from boot order] and press x on [Legacy Floppy Drives] to move it to [Boot
priority order]. Then, press + to move it to desired priority order.
* The position next to "CD-ROM" is recommendable.
Configuring Your Server 4-7