General Description - NEC Express5800 User Manual

2-4 General Description

1 Front mask
Open the upper door when accessing the file bay. Remove the front mask when
installing/removing the 5.25-inch device, 3.5-inch device, optical disk drive, floppy disk drive,
and/or hard disk drive.
2 Front USB connector
Connect the USB device to this connector.
3 Optical disk drive
The optical disk drive reads data from the inserted CD-ROM or DVD-ROM.
The drive is equipped with the following:
Open/Close button to eject the tray
•
Access lamp that indicates the disk access status
•
Emergency hole to forcibly eject the tray
•
4 5.25-inch device bay
Up to two backup file devices of 5.25-inch width such as DAT drive or MO drive may be
installed in the 5.25-inch device bay.
An optical disk drive is factory-installed on the top of bay.
5 3.5-inch floppy disk drive (option)
Reads/writes data from/to the 3.5-inch floppy disk inserted.
The floppy disk drive is equipped with the following:
Eject button to eject the floppy disk
•
Access lamp that indicates the floppy disk access status
•
6 Disk access lamp (green)
The disk access lamp is lit while the system accesses to a built-in hard disk drive. If the built-in
hard disk drive is connected to the proper optional board, this lamp can be lit only when the
LED cable provided with the system is connected.
7 POWER/SLEEP lamp (green)
Lights in green when the server is powered on. Blinks when the system is placed in the sleep
mode.
8 POWER/SLEEP switch
The POWER/SLEEP switch is used to turn the power of the server ON/OFF. If you press this
switch once, the power is turned on with the POWER/SLEEP lamp going on green. If you
press the switch again, the power is turned off.
Some OS setting can provide the function of switching to the power saving (sleep) mode. If
you press the POWER/SLEEP switch once after the setting, the system is entered into the
power saving mode with the POWER/SLEEP lamp blinking green. If you press the switch
again, the system is returned to the normal state. (Depending on installed optional boards, the
function cannot be provided.)
9 Release tabs (3 at an end of front mask)
The release tabs are provided to release the lock of the front mask. Pull the tabs to remove
the front mask.
10 File bay
The file bay contains both a 5.25-inch device bay and a 3.5-inch device bay.