NEC Express5800 User Manual page 92

4-32 Configuring Your Server
The following describe the clearing procedure.
Do not disassemble, repair, or alter the server.
Never attempt to disassemble, repair, or alter the server on any occasion other
than described in this manual. Failure to follow this instruction may cause an
electric shock or fire as well as malfunctions of the server.
Clearing CMOS Data
1.
See the section "Preparing for Installation and Removal" as described in Chapter 9 of this
guide to prepare.
2.
Remove the left side cover (see Chapter 9).
3.
Install the jumper on position 3 - 2 (CMOS clear) of the jumper block. See the figure on
the previous page to find the location of this jumper.
4.
Reinstall the left side cover (see Chapter 9).
5.
Connect the power cord to the server.
IMPORTANT:
on.
6.
After five seconds later, remove the power code.
7.
Remove the left side cover (see Chapter 9).
8.
Reinstall the jumper.
9.
Reinstall the server and then turn on the power.
10.
Press F2 at the prompt to run the BIOS SETUP utility, and select "Load Setup Default" at
the Exit menu.
WARNING
The power code is only connected, need not be turned