NEC Express5800 User Manual page 229

Hide thumbs Also See for Express5800:
Table of Contents

Advertisement

The keyboard or mouse fails to operate:
Is the cable properly connected?
→ Make sure that the cable is connected to the correct connector on the rear of the
server.
→ The keyboard or mouse does not operate if it is connected when the server is
powered (not applicable to USB devices). Power of the server first and connect it
properly.
Are the server drivers installed?
→ Refer to the manual that comes with your OS to check that the keyboard and
mouse drivers are installed. (These drivers are installed along with the OS.) Some
OS's allow you to change the keyboard and mouse settings. Refer to manual that
comes with your OS to check that the keyboard and mouse settings are correct.
Fail to access (read or write) to the floppy disk:
Does the floppy disk drive contain a floppy disk?
→ Insert a floppy disk into the floppy disk drive until it clicks.
Is the floppy disk write-protected?
→ Place the write-protect switch on the floppy disk to the "Write-enabled" position.
Is the floppy disk formatted?
→ Use a formatted floppy disk or format the floppy disk in the floppy disk drive.
Refer to the manual that comes with the OS for formatting a floppy disk.
Are the cables properly connected?
→ Make sure that the interface cable and the power cable (or cord) are connected to
the correct connector of the server. Also make sure the connection order is correct.
Is BIOS configuration correct?
→ You must change the BIOS configuration as follows to use the internal floppy disk
drive.
<Menus to check: [Main] - [Legacy Diskette A:] - [1.44/1.25MB 3 2/1"]>
Save the setting and restart the server. Run BIOS SETUP again, and select [Boot]
- [Excluded from boot order] and press x on [Legacy Floppy Drives] to move it to
[Boot priority order]. Then, press + to move it to desired priority order.
* The position next to "CD-ROM" is recommendable.
Troubleshooting 8-11

Advertisement

Table of Contents
loading

Table of Contents