Creating "Windows Server 2003 Oem-Disk For Expressbuilder - NEC Express5800 User Manual

F-6 Installing Windows Server 2003
INSTALLING WINDOWS SERVER 2003
Preparations for Installation
NEC EXPRESSBUILDER DVD
Microsoft Windows Server 2003 Standard Edition (CD-ROM), Microsoft Windows
Server 2003 R2 Standard Edition (CD-ROM)
Windows Server 2003 Service Pack (CD-ROM)
User's Guide
Getting Started
Windows Server 2003 OEM-Disk for EXPRESSBUILDER

Creating "Windows Server 2003 OEM-Disk for EXPRESSBUILDER"

Before installing, create Windows Server 2003 OEM-Disk for EXPRESSBUILDER.
NOTE:
EXPRESSBUILDER" for NEC Express5800 Server which you are
going to install Windows Server 2003, you do not need to create it
again.
You can create Windows Server 2003 OEM-Disk for EXPRESSBUILDER with the following two
procedures.
Create from the menu which appears when running NEC Express5800 Server with
NEC EXPRESSBUILDER.
If you have only NEC Express5800 Server to create Windows Server 2003 OEM-Disk for
EXPRESSBUILDER, use this procedure.
If Windows Server 2003 or Windows can be operated on NEC Express5800 Server, you can use the
other procedure described later.
Follow the steps below.
1.
Prepare one 3.5-inch floppy disk.
2.
Turn on your NEC Express5800 Server.
3.
Insert the NEC EXPRESSBUILDER DVD into the optical disk drive of the server.
4.
Press the RESET switch or press Ctrl, Alt and Delete to reboot the server. (You may also
turn off and then on again to reboot the server.)
The system will boot from the DVD-ROM and NEC EXPRESSBUILDER starts.
5.
Select [Create the OEM-DISK for Windows] from [Tools Menu] step.
6.
Insert a floppy disk into the floppy disk drive.
If you have already "Windows Server 2003 OEM-Disk for