NEC Express5800 User Manual page 284

9-28 Upgrading Your Server
Installation of N8117-01A RS-232C Connector Kit
Install the board to be connected to the PCI board slot depending on the following procedure. Refer
to the manual provided with the connector kit.
1.
Remove the PCI board retention spring, then remove the additional slot cover.
IMPORTANT:
2.
Install the bracket securely by making sure that the end of the bracket is inserted into the
frame guide of the server.
IMPORTANT:
depending on the server you are going to install the connector kit. The
PCI bracket of low-profile type is factory installed. If you are going to
install the connector kit in the full-height PCI slot, you need to replace
the bracket.
Save the removed slot cover carefully.
Replacement of the PCI bracket may be required