NEC Express5800 User Manual page 293

Hide thumbs Also See for Express5800:
Table of Contents

Advertisement

Installation
Install a file device in the following procedure. This section describes how to install an optional
SCSI device, for an example:
1.
Provide the proper setting for the device.
See the table below for the settings of the devices which can be installed in the device bay.
Device
SCSI device
* If the terminator is not attached to the optional internal SCSI cable, set the termination
resistance to ON.
2.
See the section "Preparing for Installation and Removal" described earlier to prepare.
3.
Remove the left side cover and front mask as described earlier in this chapter.
4.
Remove all the cables from the factory-installed optical disk drive and the devices
installed in the device bay.
5.
Remove the screws securing the hard disk drive bay.
6.
Pull out the file bay from the server while pushing the release tabs on top and bottom of
the file bay.
5.25-inch device
Termination resistance OFF*
Screw
1
Release tab
Upgrading Your Server 9-37
1
2
Release tab

Advertisement

Table of Contents
loading

Table of Contents