Asf Unit Removal - Epson STYLUS PHOTO 925 Service Manual

EPSON Stylus Photo 925

4.2.9 ASF Unit removal

1. Remove the Housing from the printer. (Refer to 4.2.1 "Housing removal")
2. Remove the LD roller shaft holder from the printer. (Refer to 4.2.7 "LD Roller
removal")
3. Remove the two screws (C.B.S. TITE, 3x6, F/ZN and C.B.S. TITE(P4), 3x6, F/
ZN) securing the ASF Unit to the printer body.
C.B.S. TITE, 3x6, F/ZN
Figure 4-42. Removing the ASF Unit
4. Disconnect the cables from the ASF Unit.
5. If the Change Lever has been set in the front position, push it down rearward and
remove the ASF Unit.
Figure 4-43. Position of Change Lever
Disassembly and Assembly
6.
C.B.S. TITE (P4), 3x6, F/ZN
7.
Change Lever
Disassembly
Pull off the spur gear 23.2 mounted at the right side of the ASF Unit.
Figure 4-44. Pulling off the Spur Gear 23.2
Remove the two Compression Springs from the ASF Unit.
Compression Spring 4.96
Compression Spring
Figure 4-45. Removing the Compression Spring
Revision A
Spur Gear 23.2
95