Epson STYLUS PHOTO 925 Service Manual page 101

EPSON Stylus Photo 925
6. Remove the five screws (C.B.S SCREW, 3x4, F/ZN and C.B.S SCREW, 3x6, F/
ZN) securing the Cutter Unit.
C.B.S SCREW, 3x4, F/ZN
Figure 4-58. Removing the Cutter Unit (1)
Disassembly and Assembly
C.B.S SCREW, 3x6, F/ZN
Disassembly
7. Move the CR Unit to the left end, and remove the Cutter Unit in the numerical order as
shown below.
2
Cutter Unit
Figure 4-59. Removing the Cutter Unit (2)
T
Connect the Cutter Motor Connector Cable and CT Sensor
Connector Cable to the connectors (CN17 and CN15) on the
Main Board securely.
T
Tightening torque for screws
• Two screws securing the Cutter Cover Bottom:
C.B.S SCREW, 3x6, F/ZN
• Six screws securing the Cutter Unit:
C.B.S SCREW, 3x6, F/ZN
C.B.S SCREW, 3x4, F/ZN
T
Once the gear shaft which transmits the driving force from the
A D J U S T M E N T
PF Motor to the paper eject roller (in the cutter mechanism) has
R E Q U I R E D
been removed or it has been replaced with a new one, apply an
appropriate amount of grease G-26 to the specified points.
(Refer to Figure 6-12. "Lubrication point 11" in Chapter 6.)
T
Once the Cutter Unit has been removed, make the following
adjustments:
1. Cutter position adjustment
2. Printing on A4-size noramal paper
Revision A
1
: 5 ~ 7kgf.cm
: 8 ~ 10kgf.cm
: 8 ~ 10kgf.cm
101