EPSON Stylus Photo 925
T
Before installing the LD Roller, make certain that the projection
of the LD Roller is fit in the round hole of the clutch as shown
below.
Round hole in the Clutch
Protrusion on the LD Roller Shaft
Figure 4-35. Assembling the Clutch Mechanism
Disassembly and Assembly
T
When connecting the cable to the connector of the PE Sensor,
fasten the cable to the LD Roller Shaft Holder as shown below.
T
When installing the LD Roller Shaft Holder on the printer
mechanism, set the Change Lever to front and place the paper
return side in the ASF Frame.
Change Lever
Figure 4-37. Installing the LD roller shaft holder
T
Make certain that the cut side of the LD Roller faces inside.
Disassembly
PE Sensor Cable
Figure 4-36. Installing the PE sensor cable
Revision A
Paper return side
92