EPSON Stylus Photo 925
T
Tightening torque for screws
•
Five screws securing the Housing Lower Cover Left Rear/Front:
C.B.P-TITE SCREW, 3x8, F/ZN
C.B.S SCREW, 3x6, F/ZN
T
Once the combination gear 47, 19.2 has been removed or when it
A D J U S T M E N T
has been replaced with a new one, be sure to apply an
R E Q U I R E D
appropriate amount of grease G-26 to the gear shaft.
(Refer to Figure 6-11. "Lubrication point 10" in Chapter 6.)
Disassembly and Assembly
4.2.3.2 Housing Lower Cover Right Rear and Front removal
1.
: 5 ~ 7kgf.cm
2.
: 5 ~ 7kgf.cm
Disassembly
Remove the Housing from the printer. (Refer to 4.2.1 "Housing removal")
Remove the two screws (C.B.S SCREW, 3x6, F/ZN and C.B.P-TITE SCREW,
3x8, F/ZN) securing the Housing Lower Cover Right Rear and remove the
Housing Lower Cover Right Rear.
Housing Lower Cover Right Rear
C.B.P-TITE SCREW, 3x8, F/ZN
Figure 4-13. Removing the Housing Lower Cover Right Rear
Revision A
C.B.S SCREW, 3x6, F/ZN
83