Asf Unit Removal - Epson PH890 Service Manual

EPSON Stylus Photo 890/1290

4.2.10 ASF Unit Removal

1. Remove HOUSING. (Refer to Section 4.2.1.)
2. Remove the following cables from the cable clamp in the left side of the ASF
Assembly.
n
ASF HP sensor cable
n
MOTOR ASSEMBLY, PF cable
3. Disconnect the ASF HP sensor cable from the connector on the sensor.
4. Remove the head FFC from the ASF Unit.
5. Remove 1 screw (CBS Sems, 3x6) and SHAFT, MOUNT, CR that are securing
the ASF Unit to FRAME, BOTTOM at the rear right and rear left, respectively.
ASF viewed from the right
CBS Sems (3x6)
Figure 4-29. ASF Unit Removal (1)
6. Tilting the paper support sub unit, release the hook fixing the ASF Unit to
FRAME, BOTTOM, and remove the ASF Unit toward the rear.
DISASSEMBLY AND ASSEMBLY
ASF viewed from the left
SHAFT, MOUNT, CR
Disassembly Procedures
Paper Support Sub Unit
Figure 4-30. ASF Unit Removal (2)
Hook in the ASF Unit
Figure 4-31. ASF Unit Removal (3)
Revision B
101