Waste Drain Ink Pad Unit Removal - Epson STYLUS PHOTO 925 Service Manual

EPSON Stylus Photo 925

4.2.10 Waste Drain Ink Pad Unit removal

1. Remove the one screw (C.B.P-TITE SCREW, 3x8, F/ZN) found at the button of
the printer body, and remove the Waste Drain Ink Pad Unit.
Figure 4-50. Removing the Waste Drain Ink Pad Unit
2. Disengage the three hooks and remove the Waste Drain Ink Pad Unit.
Figure 4-51. Removing the Waste Drain Ink Pad Cover
3. Remove the Waste Drain Ink Pad from the Waste Drain Ink Tray.
Disassembly and Assembly
C.B.P.-TITE SCREW, 3x8, F/ZN
Waste Drain Ink Pad Unit
Hooks
T
The Waste Drain Ink Pad is composed as shown below. In
installation, take care not to confuse the positions of the Waste
Drain Ink Pad members.
Figure 4-52. Positions of Waste Drain Ink Pad members
T
Be sure to place the ink tube in the correct position on the Waste
Drain Ink Pad. Placing the ink tube in a wrong position can
cause ink leakage.
T
When the Waste Drain Ink Pad has been replaced with a new
A D J U S T M E N T
one, make the following adjustment:
R E Q U I R E D
• Resetting the Protective Ink Counter
T
W A R N I N G Make sure the tip of the waste ink tube is located at correct
position when reassembling the waste ink tube. Otherwise it will
cause ink leakage.
Disassembly
Revision A
Top
Middle
Middle
Bottom
98