Ld Roller Removal - Epson STYLUS PHOTO 925 Service Manual

EPSON Stylus Photo 925

4.2.7 LD Roller removal

1. Remove the Housing from the printer. (Refer to 4.2.1 "Housing removal")
2. Take the Head FFC off from the Head FFC holder located along the LD roller
shaft holder.
3. Remove the one screw (C.B.S. SCREW, 3x6, F/ZN) securing the Head FFC
Grounding Plate to the Main Frame, and remove the Head FFC Grounding Plate.
Head FFC Grounding Plate
C.B.S. SCREW, 3x6, F/ZN
Figure 4-31. Removing the Head FFC Grounding Plate
4. Remove the two screws (C.B.S. SCREW, 3x6, F/ZN) securing the LD Roller Shaft
Holder to the Main Frame. (The screw on the right side is found in the rear.)
C.B.S. SCREW, 3x6, F/ZN
LD Roller Shaft Holder
Figure 4-32. Removing the LD roller shaft holder (1)
Disassembly and Assembly
5. While placing the ASF Hopper in the ASF Frame, disengage the hooks of the LD
Roller Shaft Holder by pulling them up and remove it.
ASF Hopper
Figure 4-33. Removing the LD roller shaft holder (2)
6. Disconnect the cable from the PE Sensor connector mounted on the LD Roller
Shaft Holder.
7. From the LD Roller Shaft Holder, remove the LD Roller integral with the Clutch
Mechanism.
LD Roller Shaft Holder
Clutch Mechanism
Figure 4-34. Removing the LD Roller
Disassembly
Revision A
Hooks
LD Roller
Auxiliary Roller
91