Epson STYLUS PHOTO 925 Service Manual page 93

EPSON Stylus Photo 925
T
When installing the LD Roller Shaft Holder on the printer
mechanism, take care not to damage the teeth of the spur gear
35.2 or spur gear 23.2.
Spur Gear 23.2
Figure 4-38. Installing the Spur Gears 35.2 and 23.2
T
To secure the LD Roller Shaft Holder to the printer mechanism,
tighten the two screws in the numerical order as shown below.
C.B.S. SCREW, 3x6, F/ZN
1
LD Roller Shaft Holder
Figure 4-39. Tightening the Screws to secure the LD Roller Shaft Holder
Disassembly and Assembly
Spur Gear 35.2
A D J U S T M E N T
R E Q U I R E D
2
Disassembly
T
Tightening torque for screws
• One screw securing the Head FFC Grounding Plate:
C.B.S. SCREW, 3x6, F/ZN : 8 ~ 10kgf.cm
• Two screws securing the LD Roller Shaft Holder:
C.B.S. SCREW, 3x6, F/ZN : 8 ~ 10kgf.cm
T
Once the LD Roller has been removed or when it has been
replaced with a new one, be sure to apply an appropriate amount
of grease G-26 to the specified points. Refer to
• Figure 6-4. "Lubrication point 3" in Chapter 6.
• Figure 6-5. "Lubrication point 4" in Chapter 6.
Revision A
93