Epson STYLUS PHOTO 925 Service Manual page 61

EPSON Stylus Photo 925
Observation
Paper is not ejected completely and
jammed around the Front Frame.
Although the first sheet is fed from the
ASF Unit, the next sheet is not fed and
an error display appears.
The paper is not transported by the PF
Roller.
*:In case "Paper Jam" error occurs for any of the reasons above, the jammed paper can come in contact with the nozzle surface of the print head, thus damaging the print head.
Troubleshooting
Table 3-5 Check Points for "Paper Jam" Error (continued)
Unit/part in
LCD Indication
Question
*
Roll paper has Front Frame
been backed out of
the printer or there
is a paper jam. For
roll paper, use the
roll paper knobs to Paper Eject
rewind the paper Roller
onto the roll, then
press the Roll
Paper button.
For jammed paper,
see your printer
documentation for
information about
clearing the jam.
LD Roller Shaft
Holder
Paper Guide
Top/Front Paper
Guide*
Unit Level Troubleshooting
Check Points
1. Check to see if the Star Wheel Roller is out of position.
2. Check to see if the Front Frame has been installed
properly.
3. Check to see if the Front Frame is deformed.
1. Check to see if the Paper Eject Roller has been
installed properly.
2. Check to see if the gear of the Paper Eject Roller
rotates properly.
Paper Eject Roller Gear
1. Check to see if the Torsion spring 0.22 comes off on
the both PE sensor lever.
1. Check to see if the Paper Guide Top/Front Paper
Guide has been installed properly.
Paper Guide Top
Front Paper Guide
Revision A
Remedy
1. Install the Star Wheel Roller properly.
2. Install the Front Frame properly.
3. Replace the Front Frame with a new one.
1. Install the Paper Eject Roller properly.
2. Install the Paper Eject Roller gear properly.
1. Set the torsion spring 0.22 in the proper
position on the PE Sensor Lever.
1. Install the Paper Guide Top/Front Paper Guide
properly.
61