Asf Unit Removal - Epson Stylus PHOTO 1270 Service Manual

EPSON Stylus Photo 870/1270

4.2.10 ASF Unit Removal

1. Remove HOUSING. (Refer to Section 4.2.1.)
2. Remove the following cables from the cable clamp in the left side of
the ASF Assembly.
!
ASF HP sensor cable
!
MOTOR ASSEMBLY, PF cable
3. Disconnect the ASF HP sensor cable from the connector on the
sensor.
4. Remove the head FFC from the ASF Unit.
5. Remove the one screw (CBS Sems, 3x6) and SHAFT, MOUNT, CR that
are securing the ASF Unit to FRAME, BOTTOM at the rear right and
rear left, respectively.
ASF viewed from the right
CBS Sems (3x6)
Figure 4-29. ASF Unit Removal (1)
6. Tilting the paper support sub unit, release the hook fixing the ASF
Unit to FRAME, BOTTOM, and remove the ASF Unit toward the rear.
Disassembly And Assembly
ASF viewed from the left
SHAFT, MOUNT, CR
Disassembly Procedures
Paper Support Sub Unit
Figure 4-30. ASF Unit Removal (2)
Hook in the ASF Unit
Figure 4-31. ASF Unit Removal (3)
Revision B
97