Panel Unit Removal - Epson STYLUS PHOTO 925 Service Manual

EPSON Stylus Photo 925

4.2.2 Panel Unit removal

1. Remove the Housing from the printer. (Refer to
2. Remove the four screws (C.B.P-TITE SCREW, 3x8, F/ZN) securing the Panel
Unit to the Housing and remove the Panel Unit.
C.B.P-TITE SCREW, 3x8, F/ZN
Figure 4-8. Removing the Panel Unit
3. Disconnect the Panel FFC from the Panel Board.
Disassembly and Assembly
4.2.1 "Housing removal")
Disassembly
T
The buttons will come off when the Panel Unit is removed from
the Housing. In installation, locate the buttons as shown below.
Figure 4-9. Installing the Buttons
T
Tightening torque for screws
• Four screws securing the Panel Unit:
C.B.P-TITE SCREW, 3x8, F/ZN: 5 ~ 7kgf.cm
Revision A
81