Housing Removal - Epson STYLUS PHOTO 925 Service Manual

EPSON Stylus Photo 925

4.2.1 Housing removal

1. Open the printer cover and remove the two screws (C.B.S TITE-R SCREW, 3x6,
F/UC) securing the Housing in the front of the printer body.
C.B.S TITE-R SCREW, 3x6, F/UC
Figure 4-2. Removing the two screws in the Front of the Housing
T
Ensure that C.B.S-TITE-R 3 x 6 F/US screws are used for the
C A U T I O N
two screws on the front side of the printer. The tips of these
screws are rounded for user's safety.
Disassembly and Assembly
2. Remove the three screws (C.B.S SCREW, 3x6, F/ZN) securing the Housing at the
rear of the printer.
Figure 4-3. Removing the two screws at the Rear of the Housing
3. Lift the rear of the Housing slightly, disconnect the Panel FFC from the Main
Board and remove the Housing.
Figure 4-4. Removing the Housing
Disassembly
C.B.S SCREW, 3x6, F/ZN
Panel FFC
Revision A
79