Cleaning The Pw50 - Intermec PW50 User Manual

Chapter 3 — Troubleshooting and Maintaining the PW50

Cleaning the PW50

28
To cold boot the PW50
1 Disconnect the PW50 from power if externally powered.
2 Remove the battery from the PW50 for at least one second.
3 Insert the battery back into the PW50.
4 Reconnect external power if your PW50 is externally powered.
To properly maintain your PW50, you should clean it at the
recommended intervals.
To avoid possible personal injury or damage to the printer,
never insert any pointed or sharp objects into the printer.
Use only the cleaning agents specified in this section. Intermec is
not responsible for damage caused by any other cleaning
materials used on this printer. Clean the printer with a cotton
swab saturated with alcohol.
Platen roller
PW50 Workboard Printer: Identifying the parts of the PW50 to clean
regularly.
Tear bar
Paper sensor
PW50 Workboard Printer User's Guide
Printhead