Status Responses And Auto-Transmit Commands (T = 3) - Intermec EasyCoder 3240 Developer's Manual

Status Responses and Auto-Transmit Commands (t = 3)

Intermec Printer Language (IPL) Developer's Guide
This list contains the status responses and auto-transmit commands in the
order you must download them.
Status Responses and Auto-Transmit Commands (t = 3)
Status Command
GS
SO
US
US
EM
DC3
EOT
VT
BS
SI*
FS
ACK
DC1**
DC1**
DC1**
DC1 Auto-Transmit 1**
FS Auto-Transmit 1
BS Auto-Transmit 1
EM Auto-Transmit 1
US Auto-Transmit 1
DC1 Auto-Transmit 2
HT Auto-Transmit 3
SOH Auto-Transmit 3
RS Auto-Transmit 3
*Some older Intermec printers may not support this entry.
**The status responses in the above table are for standard protocol. In XON/XOFF
protocol, most of the status responses are the same; however, instead of DC1, the status
response is DC2, and instead of DC2, the status response is DC4.
See your printer user's manual for more information about protocols and status responses.
Appendix B — User-Defined Interface Tables
Hex Value Status Description
1D Buffer Already Full
0E Printhead Test Fail
1F Label Path Open
1F Ribbon Fault
19 No Label Stock
13 Buffer Now Full
04 RFID Tag Write Error
01 RFID Tag Read Error
08 Takeup Reel Full
0F Printhead Hot
1C Label at Strip Pin
06 RFID Tag Write Ok
11 Skipping
11 Printing
11 Ready
11 Clear
1C Label at Strip Pin
08 Takeup Reel Full
19 No Label Stock
1F Ribbon Fault
11 Room in Buffer
09 Imager Overrun
01 Print Job Complete and Buffer Empty
1E Insufficient RAM
91