Tadiran Telecom T207M User Manual page 241

The following table defines the special codes that may be used as part of the outside number.
Codes
*x
#0
#1
#2
#3
#4
#5
#6
#8
#9
**
##
NOTE! The number of digits that can be programmed, including dial codes, is limited by the Coral
(defined system-wide). If you try entering a longer digit string than allowed the system will give the
error message LENGTH EXCEEDED, and programming will stop.
Time is used to change the system time and date to reflect the time and date where the Coral system is
[Time]
installed.
NOTE! To set an offset time, see
Attendant Features
System Features
Delay dialing by X seconds (x = 1 to 9)
Stop dial (end of outside or network number)
Outpulsing wait period during which user is able to dial any number of digits
All digits following will be Dial Pulse
All digits following will be DTMF
Inhibits display (for Call Accounting System and key set display)
Enables display (for Call Accounting System and key set display)
Wait for second dial tone
Display '_' (for Call Accounting System and key set display)
Calibrated Opening on trunk (FlashTk)
Dial * out
Dial # out
Time Zone on page
Description
245.
230 T207M / T208M User Guide