Replacing The Battery - LifeShield Home Security Quick Setup Manual

Visual and Audible
Command Confirmations
Range: The Keychain Remote is designed to be used within 15 feet of a Console, Base or Grid Extender.
Depending on the state of the system when an arming attempt is made and whether there has been unauthorized activity since the last arming, commands will
be confirmed by either green or red blinks, and short and long beep patterns.
Green blinks indicate that the command to the system has been received and executed or that there has been no unauthorized activity since it was last armed.
Red blinks indicate that the system is not ready to arm or that there has been unauthorized activity since it was last armed.
Audible beep patterns confirm that messages have been received by the system.

Replacing the Battery

1. Use a small coin to pry off the black lens on the top of the Keychain Remote.
2. Remove the screw.
3. Turn the Keychain Remote over and remove the back cover as shown.
4. Remove the old battery and insert a fresh CR2032 3V
Lithium Battery with the plus (+) up as indicated.
5. Re-assemble the Keychain Remote by reversing Steps 1-3.
[www.LifeShield.com]
Installing the Keychain Remote
I N S T A L L I N G Y O U R S E C U R I T Y S Y S T E M
[26]