LifeShield Home Security Quick Setup Manual page 42

Mount Bracket and Magnet
1. Attach double-sided tape to the bottom of the Magnet
2. Attach Magnet to the door
3. Attach double-sided tape to the bottom of the Bracket
4. Attach the Bracket to the door frame
Install the Sensor
Once the Bracket and Magnet are attached to the door or window, Sensors may be installed. You will need to have the Handset with
you to install the Sensor.
Remove the battery tab from the Sensor
Enter the Security Menu
Before clipping the Sensor into the Bracket, press MENU on your Handset.
1. Scroll to the Security Setup and press SELECT
2. Enter Code and press SELECT (for an initial installation the default
code is 1234)
3. Scroll to Sensors and press SELECT
4. Scroll to <Add New> and press SELECT
5. Scroll to the type of Sensor (Open/Close) and press SELECT
6. Wait 5 seconds before clipping the Sensor into the Bracket. You will then have 30 seconds to complete the installation
The display shows the time remaining
Clip Sensor
Into Bracket
30 Seconds
CANCEL
7. Clip the Sensor into the Bracket.
The Handset will beep when the system finds the Sensor. This may take a few seconds.
Sensor Found
Please Wait
30 Seconds
CANCEL
8. Press OK
[www.LifeShield.com]
Sensor Added
CANCEL OK
I N S T A L L I N G Y O U R S E C U R I T Y S Y S T E M
Installing the Sensor
[22]