LifeShield Home Security Quick Setup Manual page 123

System Messages
Secondary Security Display Messages
The following table lists and describes the Secondary Security Display Messages of your LifeShield Home Security system.
Display Message
Not Monitored Message displayed when the system is Armed but is not being monitored by the Alarm Monitoring Center.
Synchronizing Message displayed if the system has temporarily lost grid communication and is in the process of reestablishing.
Not Activated Message displayed if the system has not been activated.
Message displayed on a Handset or Console if that device has not been registered into any system. The Handset or Console
Not Registered
cannot perform any functions until it has been registered into a system.
Bypass on Message displayed when a Sensor has been bypassed.
Message displayed when the system detects that your phone line has been disconnected from one of the GCs. If a phone line is
No Phone Line
available at another GC, the system will reconfigure itself in approximately 10 seconds.
Message displayed when the system has lost communications to the Internet. This can be caused by a network outage by your broadband provider,
No Internet
loss of AC power to your cable or DSL modem, a PPOE problem, loss of power to your router, failure of the router, or a wire disconnection.
Message displayed when a device has a low battery condition. If the device is a Handset, place the Handset on a Base or Charger.
LoBat: Device Name: If the device is a Base, Console, or Grid Extender, make sure that the battery is connected and AC power is available to charge the
battery in the device. If the device is a Sensor or Keychain Remote, the battery is not rechargeable and must be replaced.
Sensor Name Open Message displayed when Sensor is faulted (open).
NoA/C: Device Name: Message displayed when a device has lost AC power.
Message displayed when the system has lost communications with one of the devices in the system. The device may have lost
Lost Device:
power or been moved out of wireless range of the system. During a system reset, this message may be displayed temporarily
Device Name:
while the system is reconfiguring itself.
Day, Date and Time
Example: Thurs. 12/20 The time and date will be displayed when there are no system messages to display.
3:05p
Table 9: Secondary Security Display Messages
[103]
S U P P L E M E N T A L I N F O R M A T I O N
Display Description
[www.LifeShield.com]