LifeShield Home Security Quick Setup Manual page 33

Installing the Handset
Add the Handset to Your LifeShield System
Follow these steps for adding an additional Handset to a LifeShield system. Handsets
packed with kits are pre-registered and do not require these steps.
After the initial installation of the LifeShield System, devices may be added to enhance
access or performance.
The maximum number of devices that can be added to a LifeShield System is shown in
the table to the right.
After the Handset and Charger are installed, use a Handset or Console that is already
registered on the System to add the new Handset.
Add the Handset
GCs or Handset
<Add New>
New Handset
Existing Handset
Handset Added
Handset 2
[13]
I N S T A L L I N G Y O U R S E C U R I T Y S Y S T E M
1. On an Existing Handset or Console, use the SCROLL and SELECT buttons to navigate to
GC or Handset (Menu/Security Setup/GCs or Handset/<Add New>)
BACK SELECT
2. Press the SELECT key to <Add New>. The system will begin searching for a new Handset
Searching
60 Seconds
CANCEL
3. On the new Handset, press the SEARCH key
System Found
Please Wait
60 Seconds
CANCEL
4. The system display and audio signal will inform you the Handset is found
OK
5. You will then be given the option to edit the default name
Edit Name
6. Use DELETE to erase the current name and replace with new text by using the keypad
DELETE OK
* The system will allow a maximum of 8 Handset/Console
or Grid Extender combinations.
[www.LifeShield.com]