Use The Setting Dial Like A Potentiometer To Perform Operation - Mitsubishi Electric FR-PA07 Instruction Manual

Note
 Release the operation lock to release the PU stop by key operation.

3.3 Use the setting dial like a potentiometer to perform operation

POINT
Set "1" (setting dial potentiometer mode) in Pr. 161 Frequency setting/key lock
operation selection.
Changing example Changing the frequency from 0 Hz to 60 Hz during operation
Operation
1.
Screen at powering on
The monitor display appears.
2.
Press to choose the PU operation
mode.
3.
Change the Pr. 161 setting to "1".
(Refer to page 4 for change of the setting.)
Press twice to return the monitor to frequency monitor.
4.
Press /
REV
FWD
5.
Turn until "
appears. The blinking frequency is the set
frequency.
You need not press
REMARKS
 If blinking "60.00" turns to "0.00", the Pr. 161 Frequency setting/key lock operation
selection setting may not be "1".

Independently of whether the inverter is running or at a stop, the frequency can be set by
merely turning the
frequency setting increments of
to start the inverter.
"(60.00 Hz)
.
. (Use Pr. 295 Magnitude of frequency change setting to change the
PU indication is lit.
FWD
REV
The frequency blinks for about 5s.
.)
Display
RUN RUN MON MON
Hz Hz
PU PU EXT EXT
A
RUN RUN MON MON
Hz Hz
PU PU EXT EXT
A
RUN RUN MON MON
Hz Hz
PU PU EXT EXT
A
5