Operation Mode; Use The Setting Dial Like A Potentiometer To Perform Operation - Mitsubishi Electric FR-A700 Series Instruction Manual

Start/stop from the operation panel (PU

operation mode)

3.4.2

Use the setting dial like a potentiometer to perform operation.

POINT
Set "1" (setting dial potentiometer mode) in Pr. 161 Frequency setting/key lock operation selection.
Operation example Change the frequency from 0Hz to 60Hz during operation
1.
Screen at powering on
The monitor display appears.
2.
Press
mode.
3.
Change Pr. 161 to the setting value "
(Refer to page 43 for change of the setting.)
4.
Press
5.
Turn
The flickering frequency is the set frequency.
You need not press
REMARKS
· If flickering "60.00" turns to "0.0", the Pr. 161 Frequency setting/key lock operation selection setting may not be "1".
· Independently of whether the inverter is running or at a stop, the frequency can be set by merely turning
74
Operation
to choose the PU operation
".
(or ) to start the inverter.
until " " appears.
60.00
.
Display
PU indication is lit.
The frequency flickers for about 5s.
.