Use The Setting Dial Like A Potentiometer To Perform Operation - Mitsubishi Electric FR-E700 Basic Instruction Manual

3.4.2

Use the setting dial like a potentiometer to perform operation.

POINT
Set "1" (setting dial potentiometer mode) in Pr. 161 Frequency setting/key lock operation selection.
Changing
Changing the frequency from 0Hz to 60Hz during operation
example
Operation
1.
Screen at powering ON
The monitor display appears.
2.
Press to choose the PU operation mode.
3.
Change the Pr. 161 setting to "1".
(Refer to page 37 for change of the setting.)
4.
Press to start the inverter.
5.
Turn until "
The flickering frequency is the set frequency.
You need not press
REMARKS
If flickering "60.00" turns to "0.00", the Pr. 161 Frequency setting/key lock operation selection setting may not be "1".
Independently of whether the inverter is running or at a stop, the frequency can be set by merely turning the
Magnitude of frequency change setting to change the frequency setting increments of
Start/stop from the operation panel (PU operation)
"(60.00Hz) appears.
.
Display
PU indication is lit.
The frequency flickers for about 5s.
.)
. (Use Pr. 295
3
57