Yamaha YZF-R6T Supplementary Service Manual page 405

Manuals by Motomatrix / www.motomatrix.co.uk / The Solution For Lost Motorcycle Coded Keys
email: info@motomatrix.co.uk
CONNECTING RODS AND PISTONS
6. Install:
NOTE:
S Align the projections on the big end bearings
S Be sure to reinstall each big end bearing in its
S While compressing the piston rings with one
S Make sure that the "Y" marks a on the con-
S Make sure that the characters b on both the
7. Align:
8. Tighten:
a. Replace the connecting rod bolts and nuts
Tighten the connecting rod bolts using the
plastic-region tightening angle method.
Always install new bolts and nuts.
b. Clean the connecting rod bolts and nuts.
c. Tighten the connecting rod nuts.
d. Put a mark 1 on the corner of the connecting
5-76
S big end bearings
S connecting rod assembly
(into the cylinder and onto the crankshaft pin)
S connecting rod cap
(onto the connecting rod)
with the notches in the connecting rods and
connecting rod caps.
original place.
hand, install the connecting rod assembly into
the cylinder with the other hand.
necting rods face towards the left side of the
crankshaft.
connecting rod and connecting rod cap are
aligned.
S bolt heads
(with the connecting rod caps)
S connecting rod nuts
15 Nm (1.5 mSkg, 11 ftSlb) + 150_
with new ones.
CAUTION:
rod nut 2 and the connecting rod 3 .
ENG